Clock Setup; Display Off Setting; About Ilx-F411/Ilx-F409; Displaying The Product Information - Alpine iLX-F409 Owner's Manual

Clock Setup

[Clock] is selected on the General Setup Menu screen.
You can set the current time and the clock display type, 12-hour or 24-
hour, depending on your preference.
Setting item:
Clock
Touch [ ] or [ ] to adjust the hour, minute and AM/PM.
You can also use the number keys.
* To change to 24-hour, set "24H" to [On] (
* To set the daylight saving time (Summer Time mode), set "DST" to [On]
( ).

Display Off Setting

When [Display Off] is selected on the General Setup Menu screen, the
display is turned Off.
Setting item:
Display Off
• To cancel Display Off mode, touch the screen or any button.
• Display Off mode is canceled when the power or ACC is turned off.
• When the gear lever is shifted to the reverse (R) position and the rear
camera is connected, the rear camera image is displayed.
• When a call is received on a Bluetooth-connected phone, the incoming
call screen is displayed.
• You can also activate Display Off mode directly by touching the
[Display Off] widget on the HOME screen.

About iLX-F411/iLX-F409

[About] is selected on the General Setup Menu screen.
[About] enables you to check the Serial No., Firmware Version, Model
Name, and to initialize various settings.
You can view the version information of this product. Make note of this
information and refer to it whenever you contact Alpine Tech Support
or an Alpine-authorized dealer.
Setting item:
Setting contents:
Setting item:
Setting contents:
You can initialize all data, to restore the factory settings. Remove the
USB flash drive, etc. from the system before operation
).
1
2
3
• Do not turn on/off the power, change the ignition key position or

Installation Setup

[Installation] is selected on the General Setup Menu screen.
Vehicle Setup enables you to check the connection status of Reverse
Lead/Parking Brake Lead.
When selecting the item, the Installation check screen is displayed.
Setting item:
Setting contents:

Displaying the Product Information

Version Information
Serial No. / SYSTEM version / Firmware Version

Displaying Warranty/Copyright Information

Warranty/Copyright Information
Open source licenses / Notice

Initializing the System

Touch [Restore Factory Setting].
After the confirmation message appears, touch [Yes].
The system starts initialization.
The confirmation screen appears.
Touch [Confirm].
remove the screen panel until system restart is completed.
Installation
Reverse / Parking Brake
15
-EN