Installation Instructions
1
Mount the microphone next to the rear view mirror
and run the cable behind the factory panels. Route
as shown on the diagram on page 12.
3
Route vehicle cable in main harness from radio
cavity to glove box and connect it to OBDII
gateway behind the glove box. If the gateway is
fully occupied, unclip 1 connector from it and use
T-harness.
i407-WRA-JL
2
Run the Bluetooth microphone cable down the A
pillar along the OEM wiring. Route as shown on the
diagram on page 12.
4
At radio cavity, connect the main harness, white FM
adapter, and green SiriusXM antenna, and other
adapters to factory harness and secure them.
Jeep Wrangler
20210330v1
9/22