Pride Mobility Zero Turn 10 Owner's Manual page 39

V I I I . C A R E A N D M A I N T E N A N C E
(Joystick controller, enhanced displays, touch screens, remote controls, keyboards, cell
ELECTRONICS
phones and tablets, as applicable)
 For electronics, remove visible contamination if present.
● Turn off device and disconnect batteries.
● Never spray any liquids directly into the product(s).
● Moisten a microfi ber cloth with a mixture of 70% isopropyl alcohol/30% water solution. The cloth should
be damp, but not dripping or excessively wet. Dry surfaces thoroughly to avoid pooling of liquids and
prior to boxing.
WARNING! Follow all safety instructions for the proper use of the disinfectant and/or cleaning
agent before applying it to your product. Failure to comply may result in skin irritation or
premature deterioration of upholstery and/or power chair fi nishes.
WARNING! Never use any cleaning or disinfecting agent, solvent, lubricant, or any other product
on the brake pads, brake discs, transaxle, motor/gearbox of your mobility product. Doing so
may damage the components and/or cause them not to function properly. Property injury and/
or personal injury may result.
WARNING! Never hose off your power chair or place it in direct contact with water. Your power chair
has a painted, ABS plastic body shroud that allows it to be easily wiped clean with a damp cloth.
WARNING! Never use any chemicals to clean a vinyl seat, as they may cause the seat to become
slippery or dry out and crack. Use soapy water and dry the seat thoroughly.
BATTERY TERMINAL CONNECTIONS
 Make certain that the terminal connections remain tight and uncorroded.
 The batteries must sit fl at in the battery wells.
 The battery terminals should face in the proper direction, according to the battery wiring diagram.
WIRING HARNESSES
 Regularly check all wiring connections.
 Regularly check all wiring insulation, including the charger power cord, for wear or damage.
 Have your authorized Provider repair or replace any damaged connector, connection, or insulation that you
fi nd before using your scooter again.
PROHIBITED! Even though the scooter has passed the necessary testing requirements for
ingress of liquids, you should keep electrical connections away from sources of dampness,
including direct exposure to water or bodily fl uids and incontinence. Check electrical components
frequently for signs of corrosion and replace as necessary.
WARNING! Do not pull on electrical harnesses directly to detach them from the scooter. Always
grasp the connector itself when disconnecting the harness to prevent wire damage.
DAILY CHECKS
 With the power turned off , check the throttle. Make sure it is not bent or damaged and that it returns to the
neutral position when you release it. Do not try to repair it. See your authorized Provider if there is a problem.
 Visually inspect the tiller cable. Make sure that it is not frayed, cut, or has any wires exposed. See your
authorized Provider if there is a problem.
 Check for fl at spots on solid tires. Flat spots could adversely aff ect stability.
 Inspect the armrests for loose hardware, stress points, or damage. See your authorized Provider if there is a
problem.
 Check the brakes. This test should be carried out on a level surface with at least 3 feet (1 meter) of clearance
around your scooter.
Mid-size Scooter Series
39