Pride Mobility Zero Turn 10 Owner's Manual page 20

I I I . B AT T E R I E S A N D C H A R G I N G
NOTE: To extend battery life, always turn off scooter and remove the key when not in use.
What type and size of battery should I use?
We recommend deep-cycle batteries that are sealed and maintenance free. Both AGM and Gel-Cell are deep-cycle
batteries that are similar in performance. Do not use wet-cell batteries, which have removable caps. Refer to the
specifi cations table for size as batteries diff er depending on manufacturer.
WARNING! Corrosive chemicals are contained in batteries. Use only AGM or Gel-Cell
batteries to reduce the risk of leakage or explosive conditions.
NOTE: Sealed batteries are not serviceable. Do not remove the caps.
Why do my new batteries seem weak?
Deep-cycle batteries employ a diff erent chemical technology than that used in car batteries, nickel-cadmium
batteries (nicads) and other common battery types. Deep-cycle batteries are specifi cally designed to provide
power, drain down their charge and then accept a relatively quick recharge.
We work closely with our battery manufacturer to provide batteries that best suit your scooter's specifi c electrical
demands. Fresh batteries are shipped fully charged to our customers. During shipping, the batteries may encounter
temperature extremes that can infl uence their initial performance. Heat diminishes the charge on the battery; cold
slows the available power and extends the time needed to recharge the battery.
It may take a few days for the temperature of your scooter's batteries to stabilize and adjust to their new room or
ambient temperature. More importantly, it takes a few charging cycles (partial draining followed by full recharging)
to establish the critical chemical balance that is essential to a deep-cycle battery's peak performance and long life.
Follow these steps to properly break in your scooter's new batteries for maximum effi ciency and service life:
1. Fully recharge any new battery prior to its initial use. This charging cycle brings the battery up to about 88%
of its peak performance level.
2. Operate your new scooter in familiar and safe areas. Drive slowly at fi rst and do not travel too far from
your home or familiar surroundings until you have become accustomed to your scooter's controls and have
properly broken in your scooter's batteries.
3. Fully recharge the batteries. They should be at over 90% of their peak performance level.
4. Operate your scooter again, and fully recharge the batteries again.
5. After four or fi ve charging cycles, the batteries are able to receive a charge of 100% of their peak performance
level and are able to last for an extended period of time.
What about public transportation?
AGM and Gel-Cell batteries are designed for application in scooters and other mobility vehicles. These batteries
are Federal Aviation Administration (FAA) approved (United States only), allowing safe transportation on aircraft,
buses, and trains, as there is no danger of spillage or leakage. We suggest you contact the carrier's ticket counter
in advance to determine that carrier's specifi c requirements.
How do I change a battery in my scooter?
MANDATORY! Battery posts, terminals and related accessories contain lead and lead
compounds. Wear goggles and gloves when handling batteries and wash hands after
handling.
PROHIBITED! Always use two batteries of the exact same type, chemistry and amp-
hour (Ah) capacity. Refer to the specifi cations table with this manual and in the
manual supplied with the battery charger for recommended type and capacities.
20
Mid-size Scooter Series