Pride Mobility Zero Turn 10 Owner's Manual page 12

Speed Adjustment Dial
This dial allows you to preselect and limit your scooter's top speed.
 The image of the tortoise represents the slowest speed setting.
 The image of the hare represents the fastest speed setting.
For model 710ZT, the speed ajustment dial has three (3) speed control settings:
 The image of the leaf (ECO) represents the slowest speed setting.
 The image of the man (EV) represents the fast speed setting.
 The image of the fl ag (SPORT) represents the fastest speed setting.
Battery Condition Meter
When the key is fully inserted and turned clockwise to power up your scooter, this meter indicates the approximate
battery voltage strength. For further information on battery charging, see III. "Batteries and Charging."
Status LED (If Equipped)
The status LED alerts you to electrical problems that may occur with the scooter. The LED remains constantly lit
while your scooter is on. If your scooter develops an electrical problem, the status LED will fl ash a code. See VII.
"Basic Troubleshooting" for fl ash codes.
Key Switch
 Insert the key into the key switch and turn it clockwise to power up (turn on) your scooter.
 Turn the key counterclockwise to power down (turn off ) your scooter.
WARNING! If the key is turned to the "off" position while your scooter is in motion, the electronic
brakes will engage and your scooter will come to an abrupt stop.
Mirror Positioning and Adjustment
For information on positioning and adjusting your mirror, see V. "Comfort Adjustments."
Handbrake Lever (If Equipped)
This lever provides you with emergency stopping power. When
in motion, release the throttle control lever and gently squeeze the
handbrake lever to come to a stop.
The handbrake can be locked and used as a parking brake by squeezing the
handbrake lever fully and moving the brake lock to the locked position.
See fi gure 1. To release the brake lock, fully squeeze the handbrake.
WARNING! The handbrake is intended for use as an
emergency brake and/or parking brake only.
Off-board Charger Port
The off -board charger power cord plugs into this port during battery
charging. The off -board charger port is located on the tiller. See fi gure 5.
Electrical System Fuses
Your scooter is equipped with a series of electrical system fuses, which
help protect the off -board charging system, key switch and lighting system
from receiving an overload of electrical current. These fuses are the same
type used in automobiles and are located in a compartment on the tiller.
See fi gure 5. See VIII. "Care and Maintenance" for fuse replacement.
NOTE: Keep all electrical areas clean and free of moisture and
foreign material.
12
I I . Y O U R S C O O T E R
IDENTIFICATION KEY
1. OFF-BOARD CHARGER PORT
2. OFF-BOARD CHARGER FUSE
3. KEY SWITCH FUSE
4. LOWER HEADLIGHT FUSE
5. REAR TAIL LIGHTS FUSE
6. LEFT TURN SIGNAL FUSE
7. RIGHT TURN SIGNAL FUSE
3
5
7
Figure 5. Off-board Charger Port/Tiller
Console Fuses
Mid-size Scooter Series
1
2
4
6