Table of Contents
Advertisement
INTRODUCTION
The TEMPUS-AG-PR is a sensor device powered by a 9V battery and used only for reading and controlling the pressure of your irrigation system. Thanks to the prewired
pressure sensor, the TEMPUS-AG-PR will put the pressure under control and will alert if the tresholds are exceeded. The tresholds can be set from the MyToroTempus
application or platform. TEMPUS-AG-PR transmits data via LoRa connection to a TEMPUS-AG-4G/WF gateway.
SPECIFICATION
DIMENSIONS
Width: 10,5 cm
Height: 4,8 cm
Depth: 11,6 cm
FEATURES
Bluetooth® Smart 4.0 Low Energy
LoRa
radio communication
TM
USE
Operating temperature : -20°C to 50°C
Indoor and outdoor use
Use in humid environment IP68
(test conditions: 1h at 1m depth)
Altitude use up to 2000m
Polution level 2
Maximum relative humidity of 80% for temperatures up to 31°C and linear
decrease up to 50% of relative humidity at 40°C.
Installing the wrong type of battery may cause an explosion or fire hazard.
INSTALLATION GUIDELINES
The TEMPUS-AG-PR is made for an outdoor use. You can place it in a buried valve box or set it on a wall (concrete, brick, cinder blocks) with 2 dowels and 2
countersunk screws of 4X40 not included.
In order to clean the TEMPUS-AG-PR, use soapy water with a sponge and then a soft cloth to wipe it off.
When replacing the sensor, only use a sensor with a waterproof connector (MIPAG1XX004BAAAX).
Step 1
APP DOWNLOAD
1. On your smartphone or tablet, go to the «App Store» or to the «Play Store».
2. Search for «The Toro Company» in the search bar.
3. Once found, download the
MyToroTempus App
4. Once installed, activate the Bluetooth® of your smartphone or tablet.
CREATE AN ACCOUNT
To use TEMPUS-AG-4G / CT / MS, you need to create your MyToroTempus account.
1.
Launch MyToroTempus
app from your smartphone
2.
Select the "Registration" button.
3. Follow the steps described on the app.
Note: if you already have an account on the MyToroTempusAG.com platform, you must use the same credentials.
Developer
The Toro Company
and/or tablet.
POWER SUPPLY
9V 6AM6 ou 6LR61 Alkaline battery
(not included)
Current consumption : 0.1mA
Sensor power supply : 5VDC (TBTS)
INSTALLATION
1 Pressure Sensor
Pressure : 0 to 1600 kPa
Screw thread : 1/4"BSP
Advertisement
Table of Contents
