Table of Contents
Advertisement
Step 2
ASSOCIATION
1. Unscrew the TEMPUS-AG-MV 's cap
2. Plug the 9V 6LR61 ou 6AM6 battery and screw the cap
3. Launch MyToroTempus app from your smartphone or tablet.
4. Click on the «Add a controller» button or on the «+» button
5. Choose the TEMPUS-AG-MV from the availade controllers list.
6. (Optional) Define a name and a
7. To finish your TEMPUS-AG-MV pairing, follow the next steps described in the app.
Note: To identify your TEMPUS-AG-MV among the nearby controllers, please refer to the «Default name» present on its product label.
Security key
The security key allows to protect your controller. You can define it during the step 6 of the «ASSOCIATION» or access to further information by clicking on the
icon
at the top right of your screen.
Step 3
PAIRING WITH TEMPUS-AG-4G/WF
To optimize the LoRa
radio connection between the TEMPUS-AG-4G/WF and the TEMPUS-AG-MV controllers, we advise to install the TEMPUS-AG-MV under
TM
meters
to the TEMPUS-AG-4G/WF. We also advise to associate all your TEMPUS-AG Controller near the TEMPUS-AG-4G/WF before installing them in the valve boxes.
1. On the MyToroTempus mobile App, select your TEMPUS-AG-4G/WF, and enter pairing mode on the Information screen. (You must be connected via Bluetooth)
2. Select the TEMPUS-AG-MV previously installed.
3. Click on the top right icon
4. Click on«Remote Access».
5. Select the TEMPUS-AG-4G/WF you want to pair the controller with.
6. Click on the button «Send» or
TEMPUS-AG-4G/WF and your TEMPUS-AG-MV
7. Go back to «Remote access» screen.
8. Click on the button
to start the test.
Note:
- The message «Connection established» means that the connection is reliable.
- The message «No connection established» means that it is necessary to bring the TEMPUS-AG-MV closer to the TEMPUS-AG-4G/WF or vice versa.
Step 4
SOLENOID VALVE / PUMP WIRING
1. Plug the TEMPUS-AG-MV as shown below. Use 9V solenoid valves only for a main valve and a relay for a pump use.
Jumper wire
Step 5
CHOICE AND SENSOR SETUP
Warning, by default there are no sensor configured.
The TEMPUS-AG-MV has a + S - sensor input on which you can connect a rain sensor or a flow meter/water meter or pressure switch after cutting the blue wire.
Once the sensor is connected, it is necessary to configure it in the application.
1. Using the MyToroTempus mobile app, connect to your TEMPUS-AG-MV via Bluetooth.
2. Click on Add Sensor.
3. Select your sensor type and follow the instructions given by the application.
security key
for your controller and click on the button «Validate».
to access to the product's informations.
on the bottom of your screen to validate. Once the pairing finished, you can test the connection between your
+S- C P 1
Valve 1
Vanne 1
Valve common wire
+S- C P 1
800
Advertisement
Table of Contents
