Table of Contents
Advertisement
INTRODUCTION
TEMPUS-AG-MS is a battery powered Bluetooth® / LoRa
flow, wind speed. TEMPUS-AG-MS transmits data via LoRa connection to aTEMPUS-AG-4G/WF gateway. TEMPUS-AG-MS available in two models : MS-4 with 4 inputs (3
sensor inputs and 1 temperature input) and MS-1 with 1 input (1 sensor input).
SPECIFICATION
DIMENSIONS
Width: 10,5 cm
Height: 4,8 cm
Depth: 11,6 cm
FEATURES
Bluetooth® Smart 4.0 Low Energy
LoRa
radio communication
TM
Permament programming memory
USE
Polution level 2
Maximum relative humidity of 80% for temperatures up to 31°C and linear
decrease up to 50% of relative humidity at 40°C
Indoor and outdoor use
Use in humid environment IP68
(test conditions: 1h at 1m depth)
Operating temperature: from -20°C to 50°C
Altitude use up to 2000m
INSTALLATION GUIDELINES
The TEMPUS-AG-MS is made for an outdoor use. You can place it in a buried valve box or set it on a wall (concrete, brick, cinder blocks) with 2 dowels and 2
countersunk screws of 4X40 not included.
In order to clean the TEMPUS-AG-MS, use soapy water with a sponge and then a soft cloth to wipe it off.
Step 1
APP DOWNLOAD
1. On your smartphone or tablet, go to the «App Store» or to the «Play Store».
2. Search for «The Toro Company» in the search bar.
3. Once found, download the
MyToroTempus App
4. Once installed, activate the Bluetooth® of your smartphone or tablet.
CREATE AN ACCOUNT
To use TEMPUS-AG-4G / CT / MS, you need to create your MyToroTempus account.
1.
Launch MyToroTempus
app from your smartphone
2. Go to «My account» by typing
3. Follow the steps described on the app.
Note: if you already have an account on the MyToroTempusAG.com platform, you must use the same credentials.
TM
, Multi Sensor device. This device allows the acquisition of measurements from sensors of temperature, humidity,
Developer
The Toro Company
and/or tablet.
on icon.
POWER SUPPLY
9V 6AM6 ou 6LR61 Alkaline battery
Not included
Current consumption : 0.1mA
INSTALLATION
1 (MS-1) or 3 (MS-4) configurable inputs to choose from:
• Dry contact (rain sensor, wind sensor, ...)
• Pulse (flowmeter, wind sensor, ...)
• Analog (0-3.5V) (moisture sensor, tensiometer, ...)
1 (MS-4 only) temperature acquisition input (type Pt100) 3V5 supply sensor
The voltage value assigned to each mounted terminals is 3.3V (red wire to each
inputs).
Note: the referenced sensors in this user manual are the ones recommended for
the TEMPUS-AG-MS use.
Advertisement
Table of Contents
