Table of Contents
Advertisement
General information
1
1
2
CAUTION
Risk of fire due to overcurrent and heating of the mains cable
If mains cables are too small, they can heat up and cause a fire.
■
Use a suitable cross-section
■
Install line circuit breaker to secure against overcurrent.
POSSIBLE DAMAGE
Damage to the device
Potential risk of damage when setting the inverter down. Whenever possible, place the
inverter on its back after unpacking.
IMPORTANT INFORMATION
Loss of warranty due to incorrect installation
Observe these instructions when selecting the installation site. Failure to observe these
instructions may limit guarantee claims or render them fully null and void.
■
Be absolutely sure to maintain the clearance around the inverter in order that the in-
verter remains cool.
■
To mount the inverter, use the wall mount and fastening screws that are suitable for
the substrate.
IMPORTANT INFORMATION
Damage to the device and loss of warranty due to installation by unqualified per-
sons
The inverter may only be installed, maintained and repaired by a trained and qualified
electrician.
The electrician is responsible for ensuring that the applicable standards and regulations
are observed and implemented.
Work that could affect the electrical power system of the relevant energy supply com-
pany at the site of the solar power feed-in may only be carried out by qualified electri-
cians expressly authorised (licensed) by the energy supply company.
This includes changes to the factory-preset parameters.
© 2022 KOSTAL Solar Electric GmbH
3
4
5
6
7
8
9
10
16
Advertisement
Table of Contents
