Silvercrest SGR 150 B1 Instructions Manual page 11

You can then remove the cylinder (4, 5, 6, 7, 10) from the feed chute (11).
Proceed as follows:
First, remove the pusher (12) from the
feed chute (11). Then hold the feed
chute (11) with one hand. Use your
thumb and index finger of your other
hand to grip the edge of the inserted
cylinder and feed chute (11) and
press them together as shown in the
illustration. You can detach the
cylinder easily in this manner and
then remove it from the feed chute
(11).
Be careful when removing the cylinders (4, 5, 6, 7, 10). The blades are very
sharp! There is a risk of injury.
Please note that you cannot insert or remove the cylinder (4, 5, 6, 7, 10) while the feed chute (11)
is attached to the food grater (1).
Mains cable/mains cable duct
Now, pull the integrated
mains cable as required from
the mains cable duct and
insert the mains plug into a
socket that is always easily
accessible. You can store the
mains cable again in the
mains cable duct after use.
The electric food grater (1) is now ready to use.
Be careful when using and cleaning the cylinders (4, 5, 6, 7, 10). The blades
are very sharp! There is a risk of injury.
Electric food grater SGR 150 B1
English - 9