Operating Steps; Cleaning - Silvercrest SGR 150 B1 Instructions Manual

Electric food grater SGR 150 B1

Operating steps


Prepare the food to be processed so that it can be inserted easily in the feed chute (11).

Place a suitable bowl under the opening of the cylinder to collect the processed food.

Now insert the prepared food in the feed chute (11).

Press the Start button (2) and keep it pressed. The cylinder (4, 5, 6, 7 or 10) in use then
rotates.
To prevent blocking of the cylinder in use, the pusher (12) should be pressed
only when the Start button (2) is pressed and the cylinder rotates.

The food in the feed chute can be inserted into the cylinder using the pusher (12). When the
feed chute (11) is empty, you can insert more food if necessary.
The processed food falls forwards from the opening of the cylinder to the bowl placed previously
under the device.

After all prepared foods have been processed, release the Start button (2).
If you want to process larger quantities of food, always observe the short
operating time of 2 minutes to avoid damaging the electric food grater (1).
 Remove the mains plug from the socket.

Cleaning

WARNING! Always remove the mains plug from the socket before cleaning.
Never immerse the electric food grater (1) in water and never clean it under
running water. There is a risk of an electric shock!
WARNING! Be careful when using and cleaning the cylinders. The blades
are very sharp. There is a risk of injury!
Do not use any aggressive, abrasive or chemical cleaning agents. The surface
of the electric food grater (1) and the accessories could be damaged
irreparably.

Remove the mains cable from the socket.

Remove the 5 cylinders (4, 5, 6, 7, 10) from the storage compartment (8).

Detach the storage compartment (8) from the electric food grater (1).

Remove the pusher (12) from the feed chute (11).

Detach the feed chute (11) from the motor shaft (9).
12 - English