Connecting The Pump To The Operating Unit; Attaching/Disconnecting The Battery Pack To/From The Appliance (Fig. D); Checking The Battery Charge Level; Operation - Parkside PRPA 20-Li B2 Original Instructions Manual

Connecting the pump to the operat-
ing unit
♦ Connect the plug r of the connection cable 0
to the connection socket 9 on the operating
unit 8.
♦ Screw the union nut of the plug r onto the
connection socket 9.
Attaching/disconnecting the
battery pack to/from the appli-
ance (fig. D)
Inserting the battery pack
♦ Pull the handle 1 upwards.
♦ Flip open the battery cover y on the operating
unit 8.
♦ To insert the battery pack j into the appliance,
push the battery pack j along the guide rail
into the appliance. It clicks audibly into place.
Removing the battery pack
♦ To remove the battery pack j, press the re-
lease button for the battery pack x and pull
the battery pack j out of the appliance.
♦ Close the battery cover y on the operating unit
8.
♦ Push the handle 1 back down.

Checking the battery charge level

♦ Press the battery charge level button f to
check the status of the battery (see also main
diagram).
The status/remaining charge will be shown on
the battery display LED d as follows:
RED/ORANGE/GREEN = maximum charge
RED/ORANGE = medium charge
RED = low charge – charge the battery
PRPA 20-Li B2

Operation

NOTE
► The minimum water depth during use must be
90 mm.
Switching on/off
Switching the pump on
♦ Insert the battery pack j into the operating
unit 8 (See "Attaching/disconnecting the bat-
tery pack to/from the appliance").
♦ Press the power button 4. The charge level
indicator 3 lights up and the pump starts suck-
ing up water.
Switching the pump off
♦ Press the power button 4. The pump switches off.
♦ Remove the battery pack j from the operating
unit 8 (See "Attaching/disconnecting the bat-
tery pack to/from the appliance").

Timer

♦ With the pump q running, press the timer but-
ton 6.
The timer LEDs 7 light up.
–
Press 1 time -> 5 mins operating time
–
Press 2 times -> 10 mins operating time
–
Press 3 times -> 15 mins operating time
As soon as the set time has elapsed, the pump q
switches off automatically.
♦ To switch off the timer before the time has
elapsed, press the timer button 6 repeatedly
until all the timer LEDs 7 go out.
CAUTION!
► Keep an eye on the appliance during opera-
tion to detect automatic shut-down or dry run-
ning of the pump in good time and to avoid
damage.
GB │ IE │
7 ■