Operating Instructions - ProBreeze PB-AC04 Instruction Manual

Hinged Window Sealing Fabric Installation
1. Open window and clean frame and
casement surfaces of dust and particles.
2. Stick the velcro tape around the entire
window frame. Never stick to the
window seal as doing so will prohibit the
window from closing fully.
3. Stick the velcro tape around the entire
window casement (inside or outside).
Check to ensure the window can close
fully.
4. Attach side A of the sealing fabric
assembly to the velcro on the window
frame working from the centre outwards.
5. Close and open window to ensure no
fabric gets trapped.
6. Attach side B of the sealing fabric
assembly to the velcro on the window
casement working from the centre
outwards.
7. Open the window slightly and insert the
heat exhaust hose short connector into
the sealing fabric assembly securing
with the zippers around its lip.
8. The sealing fabric assembly is now
ready for use.
Notes
• Do not bend the heat exhaust hose in
excess of 45 degrees. It should be as
short and as straight as possible to
ensure efficient air flow.
• Do not overstretch the heat exhaust
hose as this may affect the appliances
efficiency.
12 | English

OPERATING INSTRUCTIONS

―
Turning on and off
• Press the power button once to turn the
appliance on.
• Press it again to turn the appliance off.
Adjusting the airflow direction
• To manually control the horizontal
direction of the airflow, adjust the louvre
manually. Gently turn the louvre until
the airflow is pointing in the desired
direction.
Setting the mode
• Press the mode button repeatedly to
cycle through the mode options.
• The corresponding indicator light will
light up.
Mode options
Cool Mode
Cool mode brings down the temperature of
the room you're in. You can adjust the fan
speed and set your ideal temperature.
• When the appliance is in cool mode,
press the increase or decrease buttons
to set your desired temperature, which
will be displayed.
• The temperature can be set between
16℃ and 32℃.
• Press the fan speed button repeatedly to
set your desired fan speed.
Notes: The appliance will automatically turn
off if the room temperature drops below your
selected temperature.
Dehumidifier Mode
Dehumidifier mode allows you to use your
appliance to draw moisture from the air.
When using dehumidifier mode, it is advised
to attach the continuous drainage hose so
that the water collected from the air can drain
out and you don't have to empty the water
tank as often. For instructions on attaching
your continuous drainage hose, see the
'Continuous Drainage' section below.
• Press the dehumidifier button to activate
dehumidifier mode.
• The corresponding indicator light will
turn on.
• Connect the continuous drainage hose
to the drain outlet at the bottom of the
appliance.
Note: The fan speed will be on low and can't
be adjusted.
Fan Mode
Fan mode allows you to ventilate the air in
your room without heating up or cooling it
down.
• Press the fan speed button repeatedly
to cycle through the fan speeds of high
and low.
• The corresponding indicator light will
light up
English | 13