Front Runner KSTF003T Quick Start Manual page 3

2
ASSEMBLY
2.1
2.2
PREPERATION
3
3.1
KSTF001_REV_A04
445mm
370mm
Remove
Remove
Secure the Splice Plates (Item 6) to the Foot
Rails (Items 1 & 2) as shown using M6 x 16
Flange Button Head Bolts and M6 Nyloc Nuts
(Items 9 & 10).
Torx
Secure the Stiffener Plates (Items 3, 4, & 5)
T30
to the Foot Rails (Items 1 & 2) using M6 x 16
Flange Button Head Bolts and M6 Nyloc Nuts
(Items 9 & 10)
10mm
Do this to both LH & RH Foot Rails.
Place M6 Nut Caps (Item 11) over all Nyloc
Nuts.
Fit 10 Slimsport Slats (Item 7) to assembly
2.1 using M6 x 25 Thread Forming Screws
(Item 8).
Torx
T30
Note do not fit front slat.
Cordless
Driver
Apply a little Anti Seize / oil on screw
threads before inserting. Note these are
thread forming screws.
Tightening Torque 8-10Nm /
5.9 ft lb - 7.38 ft lb. Take care when
using a cordless driver.
With the factory rails removed and starting at
the front edge of the molding, measure and
mark the dimensions as shown onto both the
LH & RH ditch moldings.
3 © 2022 FRONT RUNNER VEHICLE OUTFITTERS