Equipment Storage - stayer GID 2200 B Operating Instructions Manual

gb
should be tightened ½ turn with a wrench to compress
its washer. If a used plug is being reinstalled, it should
only require 1/8 to 1/4 turns after being seated.
- Reinstall the ignition coil rubber boot on the spark plug
securely.
- Refit the compartment cover (16).
The spark plug must be securely tightened. An
improperly tightened plug can become very hot and
possibly damage the generator.
Never use a spark plug with an improper heat range.
TRANSPORT AND STORAGE
To prevent fuel spillage when transporting or during
temporary storage, the generator should be secured
upright in its normal operating position, with the engine
switch OFF. The fuel cap vent lever is turned counter
clockwise to the OFF position. Allow the engine to cool
well before turning the fuel cap vent lever to the OFF
position.
When transporting generator:
Do not overfill the tank. (there should be no fuel in the
filler neck)
Do not operate the generator while it is on a vehicle. Take
the generator off the vehicle and use it in a well ventilated
place.
Avoid a place exposed to direct sunlight when putting
the generator on a vehicle. If the generator is left in an
enclosed vehicle for many hours, high temperature inside
the vehicle could cause fuel to vapor ze resulting in a
possible explosion.
Do not drive on a rough road for an extended period with
the generator on board. If you must transport the generator
on board. If you must transport the generator on a rough
road, drain the fuel from the generator beforehand.

EQUIPMENT STORAGE

Before storing the unit for an extended period: Be
sure the storage area is free of excessive humidity and
dust. Drain the fuel.
Gasoline is extremely flammable and explosive under
certain conditions. Do not smoke or allow flames or
sparks in the area.
Completely drain the fuel from the tank. Open the fuel
valve, start the engine and operate it in the idle position
until all remaining fuel is gone and the engine stops
automatically.
Discharge oil.
Remove spark plug and fill cylinder with 2cc's fresh oil.
Pull start motor 3-4 times to discharge the remaining oil.
Then reinstall the spark plug.
Pull the starting cord slowly until resistance is strong. At
this time, the piston is moving to the top of the compression
stroke and the valves will be closed.
REPAIR SERVICE
Our after-sales service responds to your questions
concerning maintenance and repair of your product as
well as spare parts. Exploded views and information on
spare parts can also be found under:
info@grupostayer.com
Our customer consultants answer your questions
concerning best buy, application and adjustment of
products and accessories.
DISPOSAL AND RECYCLING
The machine, accessories and packaging should be
sorted for environmental-friendly recycling.
Only for EC countries:
Do not dispose of power tools into
household waste!
According the European Guideline 2012/19/
UE for Waste Electrical and Electronic
Equipment
national right, power tools that are no longer
usable must be collected separately and disposed of in
an environmentally correct manner.
TECHNICAL DATA
= Rated power input
KW
= Nominal current
A
= Output DC Voltage
V
= Autonomy
= Weight
= Maximum power
KW
CC
= Displacement
= Oil capacity
= Fuel capacity
L
= Sound power level
WA
L
= Sound pressure level
PA
= Vibration
The values given are valid for nominal voltages [U]
230/240 V ~ 50/60 Hz - 110/120 V ~ 60Hz. For lower
voltage and models for specific countries, these values
can vary. Please observe the article number on the type
plate of your machine. The trade names of the individual
machines may vary.
Wear hearing protection!
Measured values established in accordance with
EN 62841-1.
- 26 -
and its implementation
7. REGULATIONS
into