Installing The Sensor Core - Bosch PLS User Manual

Parking Lot Sensor | PLS
Please follow the adhesive manufacturer's recommendation regarding the cure time of the two-component adhesive.
To prevent damages to the sensor base, keep the parking space unused (no car or engine running over the PLS)
until the sensor installation is finalized.
We recommend installing several sensor bases first and only then inserting the sensor cores.

2.4 Installing the sensor core

An improper installation could impact the seals and cause water to get into the sensor which will lead to
damages. A smooth and continuous operation of the parking lot sensor is at risk if the PLS is not
properly installed.
 Do not install the PLS when it is raining or snowing.
 Ensure that the inner side of the sensor base is completely dry and without impurity (i.e., dust, mud)
 before installing the sensor core.
 Make sure that the sealing rings on the cap and sensor are seated correctly.
 Do not use damaged components and only use original replacement parts.
 Do not open the sensor housing!
Risk of explosion: extreme heat can damage the battery and the sensor.
 Do not expose the sensor to temperatures above 85 °C!
 Do not expose the sensor to open flames!
When using a gas burner (for example, when removing weeds), keep a distance of at least 1.50 m between
the flame and the sensor!
© Robert Bosch France SAS 2022. All rights reserved, also regarding any disposal, exploitation, reproduction, editing, distribution, as well as in the
event of application for industrial property rights. Data subject to change without notice. Printed in France, December 2022.
Precaution
Precaution
8 | 18