3 | 18 1 General description and intended use The Parking Lot Sensor (PLS) with TPS110 sensor core is designed for detecting parked vehicles in parking lots. This user manual is valid for the PLS with TPS110 sensor core by BCDS.
Warning To ensure safe installation: ⇒ Install the PLS core (black part) into the PLS base (grey part) only after the final installation of the PLS base. ⇒ Do not bring a magnet near the PLS (this would power the device).
Page 8
Now you can mount the sensor in the center of the parking space by applying light pressure on the sensor base (see Fig. 12 Sensor base attachment). Make sure that the sensor is centered in the parking space and that the Bosch logo on the sensor base points towards the access road (see Figure 13 Sensor base installed).
Page 10
The sensor can be screwed into the base after the adhesive has cured. To simplify insertion, the arrow on the bottom of the sensor points towards the Bosch logo (see Figure 14 Installing/screwing in the sensor). After inserting the sensor, it will take approx. 2 minutes until the first measurements are carried out. During this time, the sensor should be completely screwed in to ensure optimum teaching of the sensor.