Table of Contents
Advertisement
11
T R O U B L E S H O O T I N G
REŠAVANJE PROBLEMA
SRB
ODPRAVLJANJE TEŽAV
SLO
EN
VERTUO NEXT / VERTUO POP / VERTUO PLUS
1
No light on the button.
2
No coffee, no water.
3
Coffee is not hot enough.
4
Leakage or unusual coffee flow. • Check that the water tank is well positioned.
5
Machine turns to "OFF mode".
6 Coffee grounds in the cup.
VERTUO NEXT / VERTUO POP
7
The machine doesn't start and
has light steady on. If blinking,
see next points.
8 The machine doesn't start and
light blinks alternately; 1 blink
and 1 pause.
9 Light blinks while machine is
running.
10 Light blinks and machine is not
running.
RIJEŠAVANJE PROBLEMA
HR
ОТСТРАНЯВАНЕ НА НЕИЗПРАВНОСТИ
BG
• The machine has turned OFF automatically; push the button or "UNLOCK"
the machine.
• Check the mains, plug, voltage, and fuse.
• Check that the water tank is filled.
• Check that a fresh capsule is inserted in correct position, that the handle is
properly locked and push the button to start.
• Descale if necessary.
• Open the machine head and let the capsule be ejected. Then perform a
cleaning as per cleaning section.
• Preheat cup with hot drinking water from the tap.
• Descale if necessary.
• To save energy the machine will turn off after 2 minutes of non-use.
• Perform the cleaning procedure twice.
• See paragraph on "Cleaning".
• Check that handle is properly locked.
• If you want to brew a Coffee or Espresso, check that a fresh capsule is
inserted in correct position, that the handle is properly locked and push
the button to start.
• If you are cleaning, descaling or emptying the system, check that no
capsule is inserted then close, lock the machine and push the button to
start one of these operations.
• Fill the water tank and push button to start.
• Check that handle is properly locked.
• If coffee is flowing normally, this indicates the machine is working
properly.
• If only water is flowing, the machine is executing a user request for either
cleaning, descaling or emptying the system. Refer to the corresponding
paragraph in this user manual.
• Turn the machine to "OFF mode" by pushing the button for 3 seconds and
then push it again to turn the machine ON. Now wait approximately
20 minutes to allow the machine to cool down after extensive use.
• It will take some time before the coffee flow comes out (due to barcode
reading and pre-wetting the coffee).
• Check that a fresh capsule is inserted in correct position, that the handle is
properly locked and push the button to start.
• Fill the water tank and push button to start.
• Turn the machine to "OFF mode" by pushing the button for 3 seconds
and then push it again to turn the machine ON. Now wait approximately
20 minutes to allow the machine to cool down after extensive use.
20
Advertisement
Table of Contents
