Table of Contents
Advertisement
Operation
as on the reference surface, the red and the green LED flash alternating.
Press the button at any time while the red LED is on to switch to the normal
operating mode or press and hold the button to turn the unit off. If the unit is not
used, it turns off after approximately 45 seconds.
Please Notice
The thickness of the paint of motor vehicles can be very different in one vehicle
by design, e.G. due to stone chip proof paint in some areas of the vehicle.
Therefore, only compare the coating thickness of corresponding parts, such as
the left and right front wing. Please make sure the measured surfaces are
reasonably clean.
Changing the Battery
A weak battery is indicated by all three LED flashing. Loosen the four screws on
the back of the unit with a suitable screwdriver and carefully remove the rear half
of the housing. Replace the battery 3 V CR2032 with a fresh one of the same type
and dimensions. The spend battery is pushed out of its holder towards the rear of
the unit and the fresh battery is inserted with the plus (+) side facing up. After that,
reassemble the unit and carefully tighten the screws.
VI
Advertisement
Table of Contents
