iRobot Roomba Combo i8 Owner's Manual page 7

Cleaning
Remove excess clutter from floors before cleaning. Use your robot
frequently to maintain well-conditioned floors.
• Your robot will automatically explore and clean your Home. It will return to
the charging station at the end of a cleaning job and whenever it needs to
recharge.
• To send the robot back to its charging station, tap
will indicate that the robot is seeking the charging station.
• When your robot detects an especially dirty area, it will engage Dirt Detect™
mode, moving in a forward/backward motion to clean the area more
thoroughly. The light ring indicator will flash blue.
• Tap to spot clean a designated area. The robot will spiral outward about
3 feet (1 meter) and then spiral inward to end where it started. The light ring
indicator will show a blue spiral.`
When the robot senses its bin needs to be emptied,
the light ring indicator will illuminate in a red sweeping
motion toward the rear.
Just Press CLEAN
Tap to Start/Pause/Resume
Hold for 3 seconds to end a job
. A blue light ring pattern
Charging
White Light Ring While Charging
Solid White: fully charged
Pulsing White: charging.
• Place the robot on the charging station to activate the battery.
Note: Your robot comes with a partial charge, but we recommend that
you charge the robot for 3 hours prior to starting the first cleaning job.
• If the "CLEAN" text is pulsing while charging, the robot is in the middle of a
cleaning job and will automatically resume where it left.off once recharged.
• The robot uses a small amount of power whenever it is on the charging
station. You can put the robot in a further-reduced power state when not in
use. For instructions and more details on this Reduced Power Standby Mode,
refer to the iRobot Home App.
• For long-term storage, turn off the robot by removing it from the charging
station and holding down for 10 seconds. Store the robot in a cool, dry
place.
Roomba Combo™ i8+ Owner's Guide
EN
4