Table of Contents
Advertisement
5.4 Software licences
The software in this product contains
components that are based on free and open
source software. AEG acknowledges the
contributions of the open software and
robotics communities to the development
project.
To access the source code of these free and
open source software components whose
Step 1
Remove all accessories and removable shelf supports from the oven.
Step 2
Set the maximum temperature for the function:
Let the oven operate for 1 h.
Step 3
Set the maximum temperature for the function:
Let the oven operate for 15 min.
The oven can emit an odour and smoke during preheating. Make sure that the room is ventilated.
5.6 How to set: Water hardness
When you connect the oven to the mains you have to set the water hardness level.
Use the test paper or contact your water supplier to check the water hardness level.
Step 1
Put the test paper into
water for about 1 sec. Do
not put the test paper un‐
der running water.
The colours of the test paper continue to change. Do not check water hardness later than 1 min after test.
You can change the water hardness level in the menu: Settings / Setup / Water hardness.
The table shows water hardness range (dH) with the corresponding level of Calcium deposit
and the water classification. Adjust the water hardness level according to the table.
Water hardness
Level
dH
1
0 - 7
2
8 - 14
Step 2
Shake the test paper to re‐
move the excess of water.
Test paper
license conditions require publishing, and to
see their full copyright information and
applicable license terms, visit: http://
aeg.opensoftwarerepository.com (folder
GTM3).
5.5 Initial preheating
Preheat the empty oven before the first use.
.
.
Step 3
After 1 min, check water
hardness with the table
below.
Calcium depos‐
Calcium de‐
it (mmol/l)
posit (mg/l)
0 - 1.3
1.4 - 2.5
Step 4
Set the water hardness lev‐
el: Menu / Settings / Setup /
Water hardness.
Water classifi‐
cation
0 - 50
soft
51 - 100
moderately hard
ENGLISH
13
Advertisement
Table of Contents
