Removing The Microprocessor Thermal-Cooling Assembly - Dell Latitude D610 Service Manual

Back to Contents Page
Microprocessor Thermal-Cooling Assembly
Dell™ Latitude™ D610 Service Manual
Removing the Microprocessor Thermal-Cooling Assembly
Installing the Microprocessor Thermal-Cooling Assembly
Removing the Microprocessor Thermal-Cooling Assembly
CAUTION:
NOTICE:
as the back panel) on the computer.
NOTICE:
1. Follow the instructions in
2. Remove the center control cover (see
3. Remove the keyboard (see
4. Remove the display assembly (see
5. Remove the palm rest (see
NOTE: You can remove the microprocessor thermal-cooling assembly with the fan attached.
6. Loosen in consecutive order the three captive screws, labeled "1" through "3," that secure the microprocessor thermal-cooling assembly to the system
board.
1 microprocessor thermal-cooling assembly
2 captive screws (3)
7. Lift to remove the microprocessor thermal-cooling assembly away from the system board.
Installing the Microprocessor Thermal-Cooling Assembly
1. Place the microprocessor thermal-cooling assembly on the system board.
2. Tighten the three captive screws, labeled "1" through "3," in consecutive order.
Great user manuals database on
Before you begin any of the procedures in this section, follow the safety instructions in the Product Information Guide.
To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface (such
Disconnect the computer and any attached devices from electrical outlets, and remove any installed batteries.
"Preparing to Work Inside the
"Removing the Center Control
"Removing the Keyboard").
"Removing the Display
"Removing the Palm Rest").
UserManuals.info
Computer."
Cover").
Assembly").