Table of Contents
Advertisement
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for GME TX630
Summary of Contents for GME TX630
- Page 1 TX630 POCKET SIZE 2 WATT HANDHELD UHF RADIO I N S T R U C T I O N M A N U A L...
-
Page 2: Table Of Contents
Warning: Safety information The TX630 is a radio transmitting device. • When transmitting, keep the antenna more than 5 mm from any part of the head or body. • Do not transmit near electrical blasting equipment or in explosive atmospheres. -
Page 3: Controls
8. roger-Beep tone icon: Appears when the Roger-Beep tone is enabled. 17. Channel memory indicator: Appears when selected channel is stored in Scan Memory. 9. Battery Level icon. Indicates battery charge level. Flashes when battery is almost empty. TX630 Instruction Manual Page 3... -
Page 4: Powering The Transceiver
PoWering tHe tranSCeiVer Charging the Battery Pack Your TX630 is powered by a 7.4 Volt 1000 mAh Li-ion battery pack. When the battery Your TX630 is supplied with a 40 Volt pack is new, it should be fully charged ‘plug pack’ charger and charging cradle. -
Page 5: General Operation
Li-ion battery pack. If you need to operate Scanning your TX630 in a situation where you require The TX630 draws more power from the maximum battery life (e.g. a remote site battery pack when scanning than when where there is no convenient recharging monitoring a single channel. -
Page 6: Transmitting
(and channel is clear. Do not transmit if you hear CTCSS code if applicable). Hold the TX630 any conversations. Briefly press the SQL key approximately 5 to 8 cms from your face again to close the squelch. -
Page 7: Key-Lock Function
The moDe key is used to set the various To exit the scan mode, briefly press the feature settings of the TX630. The following SCan key again. The TX630 will return to chart shows the order of these selections: normal operation and ‘SCAN’ will disappear from the display. -
Page 8: Ctcss Code Selection
The TX630 should now display the selected note: To turn CTCSS off on this channel, channel number along with HI or LO to set the CTCSS code to of. -
Page 9: Dual Watch Settings
DUP keys are pressed. To EXIT the Dual Watch mode, turn the radio off, or momentarily press the SCan key. This is equivalent to setting the DW mode to of. TX630 Instruction Manual Page 9... -
Page 10: Call Alarm Selection
The melody will be heard 7. Call alarm Selection in the speaker of the receiving radio. The TX630 provides 5 user selectable call alarm melodies to alert other users to your incoming call. When enabled, the melody... -
Page 11: Channel Chart
CHanneL CHart TX630 Instruction Manual Page 11... -
Page 12: Specifications
GME warrant the TX630 to be free from defects in 4. Effects of water or moisture penetration. material and workmanship for a period of twelve 5. Non-factory modifications.
Need help?
Do you have a question about the TX630 and is the answer not in the manual?
Questions and answers
What is error code 2 after attempting a recharge from flat battery on TX 630