Powering Off The Projector; Warning Indicator - Optoma HD70 Manual

English
14

Powering Off the Projector

1. Press the "On/Standby" button to turn off the projector
lamp, you will see a message displayed on the projec-
tor's screen.
2. Press the "On/Standby" button again to confirm, other-
wise the message will disappear after 5 seconds.
When you press "On/Standby" button second, the sys-
tem will show the timing countdown on the screen.
3. The cooling fans continue to operate for about 10
seconds for cooling cycle and the Power LED will turn
green. When the Power LED begins flashing, the pro-
jector has entered standby mode.
If you wish to turn the projector back on, you must
wait until the projector has completed the cooling cycle
and has entered standby mode. Once in standby mode,
simply press "On/Standby" button to restart the projec-
tor.
4. Disconnect the power cord from the electrical outlet
and the projector.
5. Do not turn on the projector immediately following a
power off procedure.

Warning Indicator

When the "LAMP" indicator lights solid orange, the pro-

jector will automatically shut itself down. Please contact
your local reseller or service center. See page 43.
 When the "TEMP" indicator lights solid red, it indicates
the projector has overheated. The projector will auto-
matically shut itself down.
Under normal conditions, the projector can be switched
on again after it has cooled down. If the problem per-
sists, you should contact your local dealer or our service
center. See page 43.
When the "TEMP" indicator flashes red, it indicates the

fan has failed. Please contact your local dealer or our
service center. See page 43.
Installation