Video Source; Hdmi Source; Source; Overscan - Optoma HD70 Manual

Remote Control
English
18

Using the Remote Control

Power Refer to the "Power On/Off the Projec-
tor" section on pages 13-14.
Mode Select the display mode from Cinema,
Bright, TV, sRGB and User.
Scale the image at a 16:9 aspect ratio.
16:9
Native The input source will be displayed with-
out scaling.
Contrast Control the degree of difference be-
tween the lightest and darkest parts of
the picture.
Menu Press "Menu" to launch the on-screen
display (OSD) menu. To exit OSD, Press
"Menu" again.
Automatically synchronizes the projector
Re-Sync
to the input source.
D-Sub Press "D-Sub" to choose D-Sub (15 pins)
connector source.
Video Press "Video" to choose Composite video

source.

Source Lock Select auto detection all connector ports
or lock current connector port.
S-Video Press "S-Video" to choose S-Video source.
YPbPr Press "YPbPr" to choose Component

video source.

HDMI Press "HDMI" to choose source from
HDMI connector.
Source Press "Source" to select an input signal.

Overscan

Mask off a few pixels on each edge of the
image to be displayed. Use this function
to adjust if image source happens to
have noise near any edge of the display
image.
Adjust the brightness of the image.

Brightness

User Controls