Precautions - Optoma HD70 Manual

Table of Contents
 When the
lamp reaches the
end of its life, the
projector will not
turn back on until
the lamp module
has been replaced.
To replace the
lamp, follow the
procedures listed
under "Replacing
the Lamp" section
on page 40.

Precautions

Please follow all warnings, precautions and
maintenance as recommended in this user's
guide.
▀■
Warning- Do not look into the projector's lens when the
lamp is on. The bright light may hurt your eyes.
▀■
Warning- To reduce the risk of fire or electric shock, do not
expose this projector to rain or moisture.
▀■
Warning- Please do not open or disassemble the projector
as this may cause electric shock.
▀■
Warning- When replacing the lamp, please allow unit to
cool down, and follow all replacement instruc-
tions. See page 40.
▀■
Warning- This projector will detect the life of the lamp
itself. Please be sure to change the lamp when it
shows warning messages.
▀■
Warning- Reset the "Lamp Reset" function from the on-
screen display "Options|Lamp Settings" menu
after replacing the lamp module (refer to page
34).
▀■
Warning- When switching the projector off, please ensure
the cooling cycle has been completed before
disconnecting power. Allow 90 seconds for the
projector to cool down.
▀■
Warning- Do not use lens cap when projector is in opera-
tion.
▀■
Warning- When the lamp is approaching to the end of its
life time, the message "Replacement suggested"
will show on the screen. Please contact your local
reseller or service center to change the lamp as
soon as possible.
English
3