HP StorageWorks vs80 User Manual page 25

Figure 10
Home Screen, Drive Loaded
Chapter 2
Exporting the indicated cartridge will clear the error condition. See
Cartridges on page 31. If these symptoms occur on multiple known good
cartridges, consider cleaning the tape drive. See
page 36. If a particular cartridge causes these symptoms repeatedly, that
cartridge may be defective or invalid.
Occasionally you may see the message In Transit, which indicates:
An error condition has caused a cartridge to be left between its slot and the
drive. (Power cycle or reset the autoloader to clear this condition.)
A cartridge is unexpectedly found in the mail slot opening. (Power cycle or
reset the autoloader to clear this condition. For information on resetting the
autoloader, see Resetting the Autoloader
If the tape drive has a cartridge loaded, the top line displays Drive loaded. The
cartridge currently loaded in the drive is indicated by an alternating black
block and the slot number. This display can also indicate that the specified
cartridge is being loaded, unloaded, imported, or exported. The autoloader
status line indicates the current operation. An example of this display is shown
below.
Cleaning the Tape Drive
on page 40.)
Operating the Autoloader
Exporting
on
25