Advertisement
WARNING: Be sure all tools and
!
personnel are clear before lowering
load.
6. To lower lift, pump lift foot pedal until
height locking lever disengages, stow
height locking lever then depress
release pedal.
MAINTENANCE
When not in use, lifting platform should be
stored in the fully retracted position. Keep
lift clean and well lubricated. Apply a couple
of drops of light machine to all pivoting joints
as needed. Thoroughly wipe up excess oil
to help prevent slipping and falling.
Adding oil
1. To check hydraulic oil level, remove unit
from lift and place upright on a stable,
level surface. Remove oil filler plug. Oil
should be level to oil filler plug hole.
2. If low, add high quality hydraulic jack oil
ONLY. Never use ANY other fluid. Use
of other fluid may result in hydraulic
system failure, causing sudden and
unexpected loss of load height.
Push Height Locking Lever forward
to engage locking mechanism. Pull
lever back to disengage Height
Locking Lever.
Handle
Hydraulic
Unit
Casters
Figure 1 - Motorcycle/ATV Lift Nomenclature
1 : 3
Height Locking/
Unlocking Lever
3. Install oil filler plug, install hydraulic unit
into receiver of lift. Secure with provided
bolt.
Changing oil
For longest service life, change hydraulic
oil after 7 years of use, sooner if used in
dust and grit filled environment. Do not
expose to moisture. Dry lift completely if it
becomes wet. Check pump piston and ram
of hydraulic unit periodically for signs of rust
and corrosion. Clean mildly affected areas
with a clean oily cloth. Never use abrasives
on the pump piston or ram surfaces.
1. Remove hydraulic unit from lift and
place upright on a stable, level surface.
Remove oil filler plug and drain old oil
into a suitable container.
Notice: Dispose of used hydraulic fluid
in accordance with local environmental
regulations.
2. Fill with high quality hydraulic jack oil.
Oil Filler
Plug
Lift Saddle
4
Lift
Pedal
Sleeve
Release Pedal
Hydraulic Unit
Advertisement
