Pro-Lift T-2151 Operating Instructions & Parts Manual

TROUBLESHOOTING
Symptom Possible Causes
• Release valve not tightly
Hydraulic unit will not lift
closed
load
• Overload condition
• Overload condition
Hydraulic unit bleeds off
• Hydraulic unit malfunc-
after lift
tion
• Reservoir overfilled
Lift will not lower after
• Linkages binding
unloading
• Fluid level low
• Air trapped in system
Poor lift performance
Will not lift to full exten- • Fluid level low
sion
90 DAYS LIMITED WARRANTY
For a period of ninety (90) days from date of purchase, MVP (HK) Industries,
Ltd. will repair or replace, at its option, without charge, any of its products which fails
due to a defect in material or workmanship, or which fails to conform to any implied
warranty not excluded hereby.
Performance of any obligation under this warranty may be obtained by returning
the warranted product, freight prepaid, to MVP (HK) Industries, Ltd. Warranty Service
Department, 10939 N. Pomona Ave., Kansas City, MO 64153.
Except where such limitations and exclusions are specifically prohibited by ap-
plicable law, (1) the CONSUMER'S SOLE AND EXCLUSIVE REMEDY SHALL BE THE
REPAIR OR REPLACEMENT OF DEFECTIVE PRODUCTS AS DESCRIBED ABOVE,
and (2) MVP (HK) Industries, Ltd. SHALL NOT BE LIABLE FOR ANY CONSEQUEN-
TIAL OR INCIDENTAL DAMAGE OR LOSS WHATSOEVER, and (3) THE DURATION
OF ANY AND ALL EXPRESSED AND IMPLIED WARRANTIES, INCLUDING WITHOUT
LIMITATION, ANY WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PAR-
TICULAR PURPOSE, IS LIMITED TO A PERIOD OF NINETY (90) DAYS FROM DATE
OF PURCHASE.
Some states do not allow limitations on how long an implied warranty lasts, so
the above limitation may not apply to you. Some states do not allow the exclusion or
limitation of incidental or consequential damages, so the above limitation or exclusion
may not apply to you. This warranty gives you specific legal rights, and you may also
have other rights which vary from state to state.
Corrective Action
• Contact Pro-Lift Customer
Support
• Remedy overload condition
• Remedy overload condition
• Contact Pro-Lift Customer
Support
• Drain fluid to proper level
• Clean and lubricate moving
parts
• Ensure proper fluid level
• With ram fully retracted,
remove oil filler plug to let
pressurized air escape,
then reinstall oil filler plug
• Ensure proper fluid level
6
Operating Instructions & Parts Manual
Model Number
T-2151
ATENCIÓN
!
• Leer, comprender, y seguir las instruciónes
antes de utilizar el aparato.
• El manual de instrucciónes y la informa-
ción de seguridad deben estar comunicado
en lengua del operador antes del uso.
• No seguir estas indicaciónes puede causar
daños personales o materiales.
Manufactured by: MVP (HK) Industries, Ltd.
Customer Service Agent:
10939 N. Pomona Ave.
Kansas City, MO 64153
Phone 1-866-502-5907
Utility Lift
Capacity
1,500 lbs
WARNING
!
To avoid crushing and
related injuries, NEVER work
on, under or around a load
supported only by a jack.
Ensure locking devices are
.
fully engaged
Printed in China
T-2151 M0_012012