Advertisement
BEFORE USE
Inspect lift before each use:
1. Before using this product, read the
owner's manual completely and
familiarize yourself thoroughly with the
product and the hazards associated
with its improper use.
2. Ensure that casters/wheels and lift
arms move freely. Check for and
tighten any loose assemblies. Do
not use if cracked, broken, bent or
otherwise damaged parts are noted
or if the lift is suspected to have been
subjected to a shock load. A shock
load is caused by rapidly opening and
closing the release valve while the lift
is loaded. Such operation may result
in a hydraulic overload which may
disable the hydraulic unit.
3. Verify that the product and the
application are compatible.
WARNING: Do not use for any
!
purpose other than that for which
this device is intended.
4. Owner and operators of this device
shall be aware that no serviceable
or replaceable parts are available
for this device other than those parts
listed on page 4. Any lift that appears
to be damaged in any way, is worn or
operated abnormally shall be removed
from service immediately until such
time as repairs can be made. Do not
attempt to weld, rivet or otherwise
repair this device.
5. DO NOT modify or alter this device.
It is recommended that an annual
inspection be done to this device by
qualified persons and that missing
or damaged labels, warning/safety
decals be replaced with factory
authorized labeling.
ASSEMBLY
1. Install hydraulic unit on receiver and
secure with provided M8 x 25 bolts (2).
2. Insert pin connecting hydraulic ram to
lifting frame and secure with cotter pin.
3. Install return spring by slipping one
spring loop into slot on pin with the
other spring loop onto bolt stub at
base on hydraulic unit.
CAUTION: Beware of tension force
!
of return spring
4. Install lift foot pedal into sleeve and
secure with provided hex head bolt.
5. Install handle into frame and secure
using the provided pin.
6. Ensure assembly rolls freely, lifts, locks,
and lowers easily. Get to know how the
release pedal, lift pedal, and the height
locking and unlocking mechanism work
prior to loading the lift.
OPERATION
1. Position lift under appropriate lift point
centering load on lift saddle.
2. Locate and pump the lift foot pedal until
the lift saddle comes into contact with
an appropriate lift point.
3. Only after centering the load, slowly and
carefully raise the lift arm by pumping
the lift foot pedal.
4. Continue pumping until the load has
reached desired height. Set height
locking lever forward, then press release
pedal to fully engage adjustment stops.
Secure the load using appropriate
tie down means. Four tie down loops
have been provided on the frame of
the lift, 2 fore and 2 aft. Make sure that
the height locking mechanism is fully
engaged before working on or around
the loaded lift.
WARNING: Safety tie-downs, sold
!
separately, are required for safe
operation of this device. Purchase
and use tie-downs with sufficient
capacity to hold motorcycles placed
on this jack.
Spring
attachment
points
3
Advertisement
