Wiring The Vehicle - Harmar Mobility AL500 Owner's Manual

WIRING THE VEHICLE

Vehicle Wiring Harness
Installation Instructions
1
Unwind the harness and lay it flat. One end of the
harness has a black plug . This end of the harness
goes to the back of the vehicle.
BEGIN ROUTING THE VEHICLE
2
HARNESS AT THE BATTERY
Attach the black wire to the negative terminal on the battery.
Do not attach the red wire yet.
3 Run the wiring harness under, or when possible through
the vehicle, back to the trailer hitch. Always locate the wiring
harness where it can not be snagged by road debris and
away from the vehicle's gas tank.
If the harness is too long for the vehicle, coil the
excess wire and secure it to the vehicle frame with
Do not cut or shorten the harness
cable ties.
Secure the plug about even with the end of
the hitch receiver tube.
4
Attach the red wire to the positive terminal on the battery.
5
Wire in a Standard 4-contact female flat trailer
connector to the vehicles' taillights. This will
provide power for the motor cover light.
Important Reminder: Never attempt to attach the wire harness
to a secondary power source. The harness requires direct connection
to the battery.
Caution:
R oute the harness away from the exhaust system, brake lines, fuel lines, gas tank, pinch points,
and sharp edges. Locate the wiring harness where it can not be snagged by road debris.
Self-resetting
Circuit Breaker
To vehicle's
battery
Side mount
.
COIL
EXCESS
WIRE
HERE
Side mount
TRAILER PLUG
ON LIFT HARNESS
3
To back
of vehicle
OR
Top mount
OR
Top mount
BROWN WIRE
MOTOR COVER
LIGHT
Ground for light is
provided by main
2 prong power
connector