Advertisement
30
B R A N C H C I R C U I T M O N I T O R I N G I N S TA L L AT I O N A N D C O M M I S S I O N I N G I N S T R U C T I O N S
—
ASPMETER commissioning
Using the configuration software
Open the software using either the desktop icon (if selected)
or by navigating to the location chosen previously.
In the toolbar at the top of the window, use the options
button to adjust your communication and data acquisition
settings. Default settings appear in the window; change
these as needed.
Click the scan button to have the software locate available
devices on the system.
All devices located in the scan will appear in the box adjacent
to the scan button. Click on the device you wish to configure.
Each main board with four ribbon cable connections uses two
Modbus addresses.
Below the scan window is a row of buttons: Configure device,
global resets, alarm status, and data monitoring.
When each button is selected, a unique row of tabs appears
below (Figure 1). The information in these tabs must be
configured to the system requirements. Every setting has a
default value programmed in. The next sections describe the
settings found within each tab.
Figure 1.
Advertisement
