Advertisement
14
B R A N C H C I R C U I T M O N I T O R I N G I N S TA L L AT I O N A N D C O M M I S S I O N I N G I N S T R U C T I O N S
—
ASPMETER split core
Safety
FCC Part 15 information note: This equipment has been tested
by the manufacturer and found to comply with the limits for
a class B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection
against harmful interference when the equipment is operated
in a residential environment. This equipment generates, uses
and can radiate radio frequency energy and, if not installed
and used in accordance with the instruction manual, may
cause harmful interference to radio communications. This
device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received,
including interference that may cause undesired operation.
Modifications to this product without the express
authorization of the manufacturer nullify this statement.
A qualified person is one who has skills and knowledge related
to the construction and operation of this electrical equipment
and the installation, and has received safety training to
recognize and avoid the hazards involved.
NEC 2011 Article 100: No responsibility is assumed by
manufacturer for any consequences arising out of the
use of this material.
Control system design must consider the potential failure
modes of control paths and, for certain critical control
functions, provide a means to achieve a safe state during
and after a path failure. Examples of critical control functions
are emergency stop and over-travel stop.
For troubleshooting or service-related questions, contact ABB at 800-782-8061 or at epis.component.support@abb.com
Save these instructions
This symbol indicates an electrical shock hazard exists.
Documentation must be consulted where this symbol
is used on the product.
DANGER: Hazard of electric shock, explosion
or arc flash. Failure to follow these instructions
will result in death or serious injury.
• Follow safe electrical work practices. See NFPA 70E
in the USA, or applicable local codes.
• This equipment must only be installed and serviced
by qualified electrical personnel.
• Read, understand and follow the instructions before
installing this product.
• Turn off all power-supplying equipment before working
on or inside the equipment.
• Use a properly rated voltage-sensing device to confirm
power is off. DO NOT DEPEND ON THIS PRODUCT FOR
VOLTAGE INDICATION.
• Only install this product on insulated conductors.
NOTICE:
• This product is not intended for life or safety
applications.
• Do not install this product in hazardous or classified
locations.
• The installer is responsible for conformance to all
applicable codes.
• Mount this product inside a suitable fire and
electrical enclosure.
WARNING: Loss of control
Failure to follow these instructions may cause injury,
death or equipment damage.
• Assure that the system will reach a safe state during
and after a control path failure.
• Separate or redundant control paths must be provided
for critical control functions.
• Test the effect of transmission delays or failures
of communication links.
• Each implementation of equipment using communication
links must be individually and thoroughly tested for
proper operation before placing it in service.
Advertisement
