Advertisement
A S P M E T E R S P L I T C O R E , A S P M E T E R C O M M I S S I O N I N G
—
ASPMETER commissioning
Safety
FCC Part 15 information note: This equipment has been
tested by the manufacturer and found to comply with the
limits for a class B digital device, pursuant to part 15 of the
FCC Rules. These limits are designed to provide reasonable
protection against harmful interference when the equipment
is operated in a residential environment. This equipment
generates, uses and can radiate radio frequency energy and,
if not installed and used in accordance with the instruction
manual, may cause harmful interference to radio
communications. This device complies with part 15
of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received,
including interference that may cause undesired operation.
Modifications to this product without the express
authorization of the manufacturer nullify this statement.
This guide is intended to help the user commission the
ASPMETER panelboard monitoring system for operation.
It is assumed that the user has already installed the meter
according to the instructions in the ASPMETER installation
guide.
For troubleshooting or service-related questions, contact ABB at 800-782-8061 or at epis.component.support@abb.com
Save these instructions
This symbol indicates an electrical shock
hazard exists.
Documentation must be consulted where
this symbol is used on the product.
DANGER: Hazard of electric shock, explosion or arc
flash. Failure to follow these instructions will result
in death or serious injury.
• Follow safe electrical work practices. See NFPA 70E
in the USA, or applicable local codes.
• This equipment must only be installed and serviced
by qualified electrical personnel.
• Read, understand and follow the instructions before
installing this product.
• Turn off all power-supplying equipment before
working on or inside the equipment.
• Use a properly rated voltage-sensing device to confirm
power is off. DO NOT DEPEND ON THIS PRODUCT FOR
VOLTAGE INDICATION.
• Only install this product on insulated conductors.
NOTICE:
• This product is not intended for life or safety
applications.
• Do not install this product in hazardous or classified
locations.
• The installer is responsible for conformance
to all applicable codes
• Mount this product inside a suitable fire and electrical
enclosure.
27
Advertisement
