Interfaces - CPI TALOS T6 Installation Manual

This chapter outlines:
•
The compatible vending interface for the note validator
The interface refers to the transfer of electronic data to and from the note validator and the controlling device.
The controlling device in a vending machine is the Vending Machine Control (VMC).
The signals transferred to the note validator are control signals which may include:
The control system is ready to accept money.
The denomination of note to accept.
Whether or not notes should be returned from escrow.
Interface
Multi-Drop Bus (MDB)
Extended Bi-Directional Serial (EBDS)
Non-Isolated Serial (NISR)
Vending and gaming pulse interfaces
The following harnesses are available to support these interfaces:
Part Number
250077006C
250075007C
01-12-139C
250071043C
250070079C
250079049C
These harnesses fit onto the male connectors located on the left side of the note validator
connect to the machine controller's or coin changer's note validator interface harness.
For pinout information see
For further information on either interface harnesses or mounting kits, please contact your supplier or go to
Partners to find a CPI Authorized Service Center near you.
10
Description
Power cable (low level pulse, serial interface)
Power cable (low level pulse, serial interface)
Power cable (gaming and EBDS interface)
Multi-Drop Bus interface (MDB)
Power cable (pulse interface)
RS232 cable
Section 9.
Power Specification
24 V
115/24/12 V
115/24/12 V
115/24/12 V
Power Specification
115 VAC
24 VAC
115 VAC
24 VAC
12 VDC
N/A
Published by CPI
Talos™ T6/T8 Note Validator
(See Figure 1) and are designed to
CPI Support and select Service
01_CPI_Talos T6 and T8 Note Validator_Installation Guide_V2.0_EN