Send/Receive - Siemens SIMATIC NET S7-CPs Configuring And Installing

3.4 Setting further CP properties
Overview
In addition to the network attachment, you can also make further settings for the
specific module or you can call functions.
1. Select the Ethernet CP in the hardware configuration.
2. Select "Edit"
Depending on the type of CP you are using, the dialog displays other tabs in
addition to the "General" tab described in Section 3.3.2:
Table 3-1 Tabs and functions in the properties dialog of the CP
Tabs
General
Addresses
Options
Time-of-day synchronization
)
User **
)
Symbols **
)
DNS parameters **
Diagnostics
IP access protection
IP Configuration
Port Parameters
S7-CPs for Industrial Ethernet Configuring and Commissioning
Release 07/2010
C79000−G8976−C182−10
3 Operating the Ethernet CP with STEP 7/NCM S7
"Object Properties".
"
Settings for
S
)
Interface *
S
Module name
S
Plant designation, location identifier
S
Interface parameters for the user program
S
Time-of-day synchronization
S
SEND/RECEIVE (data length > 240 bytes)
S
Module access protection (protection level)
S
Replacing a module without a programming device
S
Ethernet profile for fault-tolerant connections
S
Individual network settings *
S
Send keepalives for connections
S
Multiplex OP connections / reserve internal CPU connection
resources
S
UDP buffering
S
File system (remember this is case−sensitive) **
S
SIMATIC mode
S
NTP mode (NTP: Network Time Protocol)
S
Specify user permissions for IT functions
S
Symbolic access to variables using IT functions
S
Specify the address of the DNS server for E−mail services (up to
32 addresses)
S
Call NCM diagnostics (special diagnostics / module diagnostics)
S
Edit IP access control list)
S
Activate/deactivate Web server
S
Activate / deactivate FTP server
S
Configure the setting of the IP address
S
Configure the way in which the IP address is configured
S
Make the network settings *
)
)
)
A−71