Springfree O200 Assembly & Installation page 7

ASSEMBLY
6b
ROD INSTALLATION
TECHNIQUE
Outside Person:
Push the mat rod, guiding the ball
along the path shown, into the mat rod
holder.
In one swi movement:
1. Forward and under the mat rod
holder.
2. Up until the ball hits the mat
underside.
3. Back towards you, guiding the ball into
the mat rod holder.
TIP - Keep the mat level when you install or uninstall the mat rods.
TIP - If you need to uninstall a mat rod, see the Disassembly Instructions.
10
Please read before continuing. DO NOT
INSTALL any of the mat rods yet.
Inside Person:
Pull the mat rod to assist the outside
person in guiding the ball.
Maintain a steady grip until the ball is
securely installed in the mat rod
holder.
ASSEMBLY
7a
FIRST ROD INSTALL
2
4
Check that the center post of every leg is correctly seated under the trampoline frame.
If they are not, adjust them now.
Check every mat rod holder tab is outside the mat rod holder pocket.
At position find the blue sticker on the frame and the blue
1
Install the mat rod at the blue sticker location into the mat rod holder at the blue
tag location.
Repeat at position . Pulling the mat edge while pushing the mat rod will be
2
required to install this second rod.
Continue installing one rod at each of the remaining positions
Move to Step 7b.
WARNING - Treat any loaded rod with caution until you are sure it is properly
installed or uninstalled. Keep your face well away from any loaded rod.
NOTE - Following the sequence shown spreads the tension evenly across the
mat. If you do not follow this sequence, it will be very di icult to attach the
mat.
TOP VIEW
5 8
3
1
7 6
tag on the mat.
.
3 4 5 6 7 8
11