Springfree O200 Assembly & Installation page 10

DISASSEMBLY
1
Outside Person:
Remove the c-clips located on the net rod sockets. Li the bottom end of the net
rods out of the net rod sockets and lower the net.
Remove the net rods from the net rod pockets and lay them flat on the ground.
Replace the c-clips in the net rod sockets to keep them safe.
Starting at one end, carefully pull the top edge of the net down over the edge of the
mat. Continue around the trampoline until the net is sitting at the bottom of the mat
rods.
WARNING - Do not remove the legs until the end of the last step. Failure to
follow these steps in the correct order could cause serious injury or damage
the trampoline.
WARNING - Never remove a net rod from its net rod pocket or disengage
(unlock) the metal joiner while the net rod is under tension. First, remove the
net rod from the net rod socket on the frame. Always ensure a solid grip when
handling and do not stand directly in front of the rods.
16
DISASSEMBLY
2a
ROD REMOVAL
TECHNIQUE
Outside Person:
When you remove a rod from the mat,
do not twist or rotate the mat edge.
This could cause serious injury or
damage the trampoline.
Hold the mat edge flat with your le
hand as shown. Push up behind the
mat rod holder tab without obstruct-
ing the opening. This prevents the ball
from catching in the mat.
Hold the mat rod near the ball end
with your palm facing up and bend
your arm at a right angle as shown.
Pull your elbow into your hip and
always push using your body weight.
Please read before continuing. Do not remove any of
the mat rods yet.
Inside Person:
Hold the mat rod with both hands as
shown to assist the outside person.
17