Start Up; Change The Program - Toshiba DWS-34AHK Instruction Manual

Start up

To start the program:
The plug shall be firstly plugged into the socket. Power supply shall be of 220-240V AC 50Hz
type, with socket of 10 A 220-240V AC. Before selecting a program, press "ON/OFF" button
turn on the dishwasher. Press the button of desired program, the corresponding indicator
will light up.
Then, press "Start/Pause" button to start.
Attention
If you press "Start/ Pause" button in the process of washing, the
every 60 seconds until started up again by pressing the "Start/ Pause" button.

Change the program

Premise: You can modify the washing program, if the dishwasher just worked for a short
time. Otherwise, the detergent may have already been released, and the appliance may
have already drained the wash water in this case, the cycle must be restarted.
Press Start/Pause Button to pause the machine when the door is closed.
Press Program Button for more than 3 seconds the machine will be in stand-by state, then
you can change the program to the desired cycle setting
(see the section entitled "Start up" ).
The Display window shows the state of the dishwasher:
a) Display window shows "-:--" ----------------------------------> stand by;
b) Display window shows "H:MM" and not blinking -------------> pause;
c) Display window shows "H:MM" and only " : " blinking ------------------------> run;
d) Display window shows "END" ------------------------> end.
Attention
If you open the door during washing, the machine will pause. When you and press the Start/Pause
Button, the machine will keep on working after 10 seconds.
If your model has broken remember function, the machine will go on to finish the selected
program after the power cut.
dishwasher beeps at
23