Start Up; Changing The Program Mid-Cycle - Toshiba DW-14F2MESS Instruction Manual

Start up
1. The plug shall be firstly plugged into the socket. Power supply shall be of
220V AC 60Hz type, with socket of 10 A 220V AC.
2. Make sure that the water supply is turned on to full pressure.
3. Open the door, press "ON/OFF" button turn on the dishwasher.
4. Press the button of desired program, the corresponding indicator will light up.
5. Then, close the door, the dishwasher will start its cycle.
Changing the program mid-cycle
A wash cycle can only be changed if it has been running for a short time otherwise, the
detergent may have already been released and the dishwasher may have already drained
the wash water. If this is the case, the dishwasher needs to be reset and the detergent
dispenser must be refilled. To reset the dishwasher, follow the instructions below:
1. Open the door a little to stop the dishwasher, after the spray arm stop working, you can
open the door completely.
2. Press the Program button for more than 3 seconds, the dishwasher will enter
standby mode.
3. Press the Program button to select the desired program.
4. Then, close the door, the dishwasher will start its cycle.
0
~
► ® ►
3 seconds
J
14