HUTTON Cotswold COT-5 Assembly Instructions

Cotswold Bench (COT-5)
Please take a few moments to check all pack contents listed.
List of fixings in pack
4 x 90mm Screws
4 x 80mm Screws
4 x Dowels
1. Slot in one side of the backrest into one of the leg/arm sections.
2. Place the seat onto the mid rail of the leg/arm section.
Then fit the other leg/arm section to the other end.
3. Screw through the two pre-drilled holes in the seat using the 80mm screws and repeat for
the other side.
4. Next screw through the pre-drilled holes at each side at the top of the leg/arm section into
the backrest using the 90mm screws. (Making sure the backrest is at its highest position in
the mortise hole).
5. Wooden dowels are supplied to fill in the pre-drilled holes in the leg/arm sections of the
chair/bench.
IMPORTANT: To minimise twisting and warping all Hutton garden furniture products should only be used on firm level ground. Softwood is a
natural material which can twist and split during periods of wet/dry, hot/cold weather. If cracks do appear it is a natural occurrence and not
a fault with the product or material. The best way to treat this is to use a cloth and rub a little pva wood glue into the crack and once dry sand
the area lightly. This will not affect the treatment of the product.
T: 01452 762089 E: office@hutton-ltd.co.uk W: huttongardenproducts.co.uk
ASSEMBLY INSTRUCTIONS
Assembly requires 2 persons.
Tools required: Pozi-drive screwdriver, hammer.
HUTTON GARDEN AND LANDSCAPING PRODUCTS
COT-5_V1
When assembling, loosely
fix together until fully
assembled then tighten all
the screws.