HUTTON Buxton Arbour Assembly Instructions

List of parts in fixings pack

--------------------------------------------
22 x 70mm Screws
6 x 80mm Screws
16 x 60mm Screws

List of parts

------------------------------------------------------
1 x Roof Sections (Two Parts)
2 x Side Panels
1 x Back Panel
1 x Storage Box Lid
1 x Storage Box Sides
1 x Storage Box Base
1 x Storage Box Front
4 x Fascia Sections
When assembling, loosely fix together until fully assembled then tighten all the bolts.
IMPORTANT CUSTOMER INFORMATION
To minimise twisting and warping all Hutton garden furniture products should only be used on firm level ground.
Softwood is a natural material which can twist and split during periods of wet/dry, hot/cold weather. If cracks do appear, it is a
natural occurrence and not a fault with the product or material. The best way to treat this is to use a cloth and rub a little PVA
wood glue into the crack and once dry sand the area lightly. This will not affect the treatment of the product.
Church Lane, Northwood Green, Westbury-on-Severn, Gloucestershire GL14 1ND www.svw2000.co.uk/hutton
Tel: 01452 762089
1. Attach one side panel to the back panel using three 70mm screws.
(Making sure the panel frame is on the inside as shown in the
photograph).
2. Repeat for the other side.
3. Attach each square frame (storage box sides) to the side panels at
the bottom. Screwing them from the inside of the square frame into
the side panels using two 70mm screws at each side.
4. Fix the front of the storage box to the square side frames using four
70mm screws.
5. Slot the base into place.
Hutton Garden and Landscaping Products
Fax: 01452 760993
Assembly Instructions
BA-Buxton Arbour
sales@hutton-ltd.co.uk