HUTTON Avon Corner Arbour Assembly Instructions

H H UTTO UTTO
garden and landscaping products

List of parts

Side panels with trellis
Corner trellis section with 2 posts
Corner trellis section with 1 post
x2 trellis panels
Back rests
Seat rests
Table leg
Table
Top Rail Section 1
Top Rail Section 2

List of parts in fixings pack

50 x 70mm Screws
4 x 80mm Screws
8 x 95mm Connector Bolts
8 x 60mm Connector Bolts
8 x 25mm Connector Caps
4 x Rubber Bungs
2 x Allen Keys
1 x Square Bit
When assembling, loosely bolt together until
fully assembled then tighten all the bolts.
This will require at least 2 people
to assemble. Power screwdriver will
also be helpful.
Assembly Instructions
N N
ACA – Avon Corner Arbour
1. Using the provided screws, fix the trellis panel with
2 long posts to the panel with 1 long post to create
the corner. The trellis needs to be flush on the
inside of all panels.
2. Using 95mm bolt and connector cap, fix the top of
one backrest to one of the long trellis sections, &
using a 60mm bolt, fix the other side of the
backrest into the insert in the corner section.
3. Next bolt the other backrest to the remaining long
trellis section and bolt to the other post of the
corner section.
4. Line up the holes at the back of the seat rest with
the bottom holes of the back rest and the holes in
the arbour posts and, using 95mm bolts and
connector caps, fix into place.
5. Fix the front of the seat into the front post of the
long trellis section and repeat 4 and 5 for the other
seat rest.
continued over....