Table of Contents
Advertisement
Figure 4. Example of Attaching One SCSI Device to the System Unit. The view is from the
side.
v If there is more than one device ( 2 in Figure 5) attached to the host system 1 ,
move the terminator 3 to the last device.
Figure 5. Example of Attaching Multiple SCSI Devices to the System Unit
Notes:
1. A SCSI device can have one (single) or two (dual) connectors on the back of the
device. Figure 6 on page 10 shows a single-connector device 1 connecting to a
dual-connector device 2 . Figure 7 on page 10 shows a dual-connector device
2 connecting to a single-connector device 1 .
2. The AS/400 host system only supports the attachment of specific external
storage devices, including the 7210 DVD-RAM Drive. Contact your IBM
authorized support personnel for information about valid attached devices and
the configurations allowed by the system.
3. When attaching multiple SCSI devices to a host system, ensure that the wide
SCSI device, such as a 7207 Tape Drive, is connected first. Any narrow SCSI
devices, such as the 7210 DVD-RAM Drive, should be connected after the wide
devices to ensure that the wide device is fully enabled.
9
Chapter 2. Setting Up
Advertisement
Table of Contents
