Installation Procedure - Toto EcoPower TET1GB Installation And Owner's Manual

Flush valve for toilet

Hide thumbs

Table of Contents

Available languages

NOTE: For retrofit installation, remove the old Flush Valve

after shutting off the control stop.

NOTE: For reclaimed water, do not use standard vacuum

breaker or control stop.

NOTE: Do not use petroleum based products or pipe

sealants.

1. Install the control stop using an

appropriate size escutcheon and a

sweat solder adapter kit, if applicable.

Thread sealing compounds should be

used on male NPT threads only.

The distance from center of the

control stop to center of the toilet

should fall within 4-1/4" to 5-1/4"

(107 mm to 133 mm).

For use with a left water supply, attach

the sensor top cover in the opposite

direction so that the sensor will be at

the front.

2. Determine the length of vacuum

breaker tube to join the Flush Valve and

fixture spud. If required, cut the vacuum

breaker tube to the proper length.

3. Assemble the spud nut assembly to the

fixture spud. Hand tighten spud nut to

fixture.