Before Installation - Toto EcoPower TET1GB Installation And Owner's Manual

IMPORTANT: Plumbing installation must be in accordance with applicable codes and
regulations. Water supply lines must be sized to provide an adequate volume of water
for each fixture. Flush all waterlines prior to operation.
Toilet and urinal Flush Valves are not interchangeable, check the model number on the
label to make sure you have the correct type. Toilet Flush Valve model numbers begin
with 'TET' and Urinal Flush Valve model numbers begin with 'TEU'.
Prior to installing your Flush Valve, install the items listed below:
Toilet bowl fixture
Drain line
Water supply line
The supply piping to these devices must be securely anchored to the building structure
to prevent the installed device moving during use. Prevent marring to the exposed
surface during installation.
IMPORTANT: Purge all air from the supply lines before connecting flush valve to the
bowl. Trapped air in supply lines may crack the china.
Except for TET6GB, TET6UB and TET6LB, install the Flush Valve so the control stop is
no less than 11-1/8" (282 mm) above the top of the bowl. For TET6GB, TET6UB and
TET6LB, install the Flush Valve such the control stop is 27" (685.8 mm) above the bowl.
see local codes for special requirements.
Avoid damaging the surface of the infrared sensor while unpacking.
The toilet Flush Valve may not function if toilet seat or lid cover are left upright and block
the sensor.
For Reclaimed Water Flush Valve:
Only use reclaimed water angle stop and vacuum breaker.
The detection range of the infrared sensor is shown on p.16.
To prevent valve malfunction, do not install a handrail or any other object within the
detection range of the sensor. Do not install the Flush Valve where sensor faces a mirror,
stainless steel wall, other highly reflective surfaces or another infrared sensor.

BEFORE INSTALLATION

- 6 -