Peavey TRANSTUBE BANDIT 112 Manual page 4

GAIN SWITCH (9)
Boosts the overall system gain. Depress to the "in" position to activate.
LOW, MID, 81 HIGH EQ (10)
Passive tone controls that regulate the low, mid, and high frequencies of the Lead channel.
POST GAIN (11)
Controls the overall volume level of the Lead channel. The final level adjustment should be made after the
desired sound has been achieved.
REVERB LEVEL (12)
Controls the overall reverb level.
EFFECTS SEND (13)
Output for supplying signals to external low-level effects or signal processing equipment.
EFFECTS RETURN (14)
Input for returning signals from external low-level effects or signal processing equipment.
EFFECTS LEVEL SWITCH (15)
Selects the effects loop operating level: -10 dBV (0.3 V RMS) when "out" and 0 dBV (1 V RMS) when "in."
RESONANCE SWITCH (16)
Used to fine-tune the low frequency range of the speaker enclosure by varying the damping factor of the
amplifier between two presets.
PRESENCE (17)
An active tone control that boosts the extreme high frequencies by 6 dB.
TM
T DYNAMICS CONTROL (18)
Adjusts the power level of the amplifier from 10 percent to 100 percent power. When set to lower settings,
the power compression simulation will be much more pronounced.
POWER LED (19)
Illuminates when AC power is being supplied to the amp
POWER SWITCH (20)
Depress the switch to the "on" position. The red pilot light (LED) will illuminate indicating power is being
supplied to the unit.
Back Panel:
BACK PANEL FEATURES
GROUND SWITCH (21)
Three position rocker-type switch, which, in most applications, should be operated in its center or zero
position. There may be some situations when audible hum and/or noise will come from the loudspeaker. If
this situation arises, position the ground switch to either positive or negative (+ or -) or until the noise is
minimized.
NOTE: Should the noise problem continue, consult your Authorized Peavey Dealer, the Peavey Factory, or a
qualified service technician. THE GROUND SWITCH IS NOT FUNCTIONAL ON 220/240 VOLT MODELS.