Peavey TKO Operating Manual

Peavey TKO Operating Manual

Tour series tnt combo; tour series tko combo
Hide thumbs Also See for TKO:

Advertisement

Tour
Series TNT Combo
Tour
Series TKO Combo
Bass Amplifiers
Operating
Manual
www.peavey.com

Advertisement

Table of Contents
loading

Summary of Contents for Peavey TKO

  • Page 1 ™ Tour Series TNT Combo ™ Tour Series TKO Combo Bass Amplifiers Operating Manual www.peavey.com...
  • Page 2 ATTENTION: Afin de réduire le risque de choc électrique, ne pas enlever le couvercle. Il ne se trouve à l’intérieur aucune pièce pouvant être reparée par l’utilisateur. Confiez I’entretien et la réparation de l’appareil à un réparateur Peavey agréé. AVIS: Dans le but de reduire les risques d’incendie ou de decharge electrique, cet appareil ne doit pas etre expose a la pluie ou a l’humidite et aucun objet rempli de liquide, tel qu’un vase, ne doit...
  • Page 6 Duración por Día en Horas Nivel de Sonido dBA, Respuesta Lenta 1 1 ⁄ 2 1 ⁄ 2 1 ⁄ 4 o menos...
  • Page 7 Peavey bass guitar amplifiers are legendary for their state of the art features, class-leading power, superb tone, and unmatched reliability. Your new Tour series TKO or TNT is no exception. Peavey’s award-winning Tour series amplifiers provide the backbone for countless touring acts worldwide. Peavey TKO and TNT combos have set the standard for bass combo performance over three decades.
  • Page 8 TNT Front Panel INPUT may occur to both units. This switch is included so you can choose the appropriate setting for your instrument. Passive pickups have a lower output, so the gain structure of the amplifier is modified to accommodate the different pickup configurations.
  • Page 9 TNT Rear Panel This button turns the compressor on or off. VOLUME This knob controls the overall volume of the amplifier. DDT™ (Distortion Detection Technique) This button prevents power amplifier clipping that can sound bad and damage speakers. The “IN” or enabled for optimum system performance.
  • Page 10 TWEETER SWITCH be switched to the OFF position. EXTERNAL SPEAKER OUTPUT Speakon™ type powered output for powering a passive enclosure. FOOTSWITCH JACK The crunch and compressor buttons MUST be pushed in to operate with the footswitch. EFFECTS LOOP The Send Jack provides a pre amp output that may be used to drive slave amplifiers and external effects processors.
  • Page 11: Graphic Equalizer

    Front Panel INPUT may occur to both units. This switch is included so you can choose the appropriate setting for your instrument. Passive pickups have a lower output, so the gain structure of the amplifier is modified to accommodate the different pickup configurations.
  • Page 12: Power Switch

    Rear Panel DDT™ (Distortion Detection Technique) This button prevents power amplifier clipping that can sound bad and damage speakers. The “IN” or enabled for optimum system performance. HEADHPHONE OUTPUT DDT INDICATOR LIGHT for the LED to flash. However, if the LED is constantly illuminated, the gain level needs to be adjusted to prevent possible equipment damage.
  • Page 13: Effects Loop

    EXTERNAL SPEAKER OUTPUT EFFECTS LOOP The Send Jack provides a pre amp output that may be used to drive slave amplifiers and external effects processors. The Return Jack provides a power amp input for the last effect in the chain. NOTE: When using the unit as a slave power amplifier, the Return Jack should be used as the input.
  • Page 14: Mains Voltage

    Tour Series TNT Combo Mains Voltage: Power Consumption: 600 W Power Amplifier Protection: DDT™ speaker protection with defeat switch Short Circuit protection Thermal protection circuit Cooling fan failure protection circuit Current limit protection circuit DC output protection circuit Minimum Load: 4 Ω...
  • Page 15 Tour Series Specifications ™ Tour Series TKO Combo Specifications Not Available At Time Of Press Features and specifications subject to change without notice. All specifications tested with mains voltage maintained at nominal level.
  • Page 16 Tour Series TNT 115 Combo Block Diagram...
  • Page 17 Tour Series TKO 115 Combo Block Diagram...
  • Page 18 NOTES...
  • Page 19 Logo referenced in Directive 2002/96/EC Annex IV (OJ(L)37/38,13.02.03 and defined in EN 50419: 2005 The bar is the symbol for marking of new waste and is applied only to equipment manufactured after 13 August 2005...
  • Page 20 Features and specifications subject to change without notice. ©2010 80305661 Printed in China...

Table of Contents