Table of Contents
Advertisement
"Clock Source," on page 25). Connect this to the word clock input of the
slave device.
Most commonly, this will be connected to the Word Clock input of an
Alesis BRC; this is necessary when transferring audio from S/PDIF input
to ADAT output in a BRC-equipped system.
As with the Word Clock input, above, the Word Clock output requires a
shielded, video-quality cable, with 75-ohm or greater impedance.
ADAT Timecode Conditioner
The 1212 I/O's ADAT Timecode Conditioner is a small device which fits
between the ADAT 9-pin sync cable and the 1212 I/O's ADAT timecode
connector. This device pre-conditions the ADAT timecode, enhancing the
1212 I/O's timecode sync capabilities.
If you will be using ADAT timecode with the 1212 I/O, please make sure
that the ADAT Timecode Conditioner is connected between the ADAT sync
cable and the ADAT sync connector on the 1212 I/O's ADAT sync input.
Adat Timecode Conditioner
ADAT Sync Cable
Korg 1212 I/O
ADAT Timecode
Conditioner
1212 I/O Breakout Cable
Installation
11
Advertisement
Table of Contents
