dji GOGGLES INTEGRA MOTION COMBO User Manual page 8

DJI Goggles Integra Motion Combo User Manual
Brake: press once to make the aircraft brake and hover in place. Press again to un-
lock the attitude.
When the aircraft is performing RTH or auto landing, press the button once to can-
cel RTH or landing.
3. Joystick
Toggle up or down to make the aircraft ascend or descend. Toggle left or right to
make the aircraft move horizontally left or right.
4. Mode Button
Press to switch between Normal and Sport mode. Press and hold to initiate RTH.
Press again to cancel RTH.
5. FN Dial
Press the dial to open the camera settings panel in the FPV view. Scroll the dial to
navigate the settings menu or adjust the parameter value, then press the dial to
confirm the selection. Press and hold the dial to exit the current menu.
The FN dial can also be used to control the camera tilt before takeoff or during RTH
and landing. Press and hold the FN dial from the FPV view and then scroll up or
down to tilt the camera. Release the dial to stop the camera tilt.
6. Shutter/Record Button
Press once: take a photo or start/stop recording.
Press and hold: switch between the photo and video modes.
7. Accelerator
Press to fly the aircraft in the direction of the circle in the goggles. Push forward to
fly the aircraft backward. Apply more pressure to accelerate. Release to stop and
hover.
8. USB-C Port
9. Power Button/Link Button
Press once to check the current battery level.
Press, and then press and hold to power the motion controller on or off.
When powered on, press and hold the button to initiate linking.
10. Lanyard Hole
8
©
2023 DJI All Rights Reserved.